★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 300-209 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/300-209-dumps.html


Exam Code: 300-209 (Practice Exam Latest Test Questions VCE PDF)
Exam Name: Implementing Cisco Secure Mobility Solutions (SIMOS)
Certification Provider: Cisco
Free Today! Guaranteed Training- Pass 300-209 Exam.

2021 Aug 300-209 burner:

Q41. Which statement is true when implementing a router with a dynamic public IP address in a crypto map based site-to-site VPN? 

A. The router must be configured with a dynamic crypto map. 

B. Certificates are always used for phase 1 authentication. 

C. The tunnel establishment will fail if the router is configured as a responder only. 

D. The router and the peer router must have NAT traversal enabled. 

Answer: C 


Q42. Which cryptographic algorithms are a part of the Cisco NGE suite? 

A. HIPPA DES 

B. AES-CBC-128 

C. RC4-128 

D. AES-GCM-256 

Answer: D 

Explanation: Reference: 

https://www.cisco.com/web/learning/le21/le39/docs/tdw166_prezo.pdf 


Q43. Which VPN solution is best for a collection of branch offices connected by MPLS that frequenty make VoIP calls between branches? 

A. GETVPN 

B. Cisco AnyConnect 

C. site-to-site 

D. DMVPN 

Answer: A 


Q44. When a tunnel is initiated by the headquarter ASA, which one of the following Diffie-Hellman groups is selected by the headquarter ASA during CREATE_CHILD_SA exchange? 


A. 1 

B. 2 

C. 5 

D. 14 

E. 19 

Answer: C 

Explanation: 

Traffic initiated by the HQ ASA is assigned to the static outside crypto map, which shown below to use DH group 5. 



Q45. Which option describes the purpose of the shared argument in the DMVPN interface command tunnel protection IPsec profile ProfileName shared? 

A. shares a single profile between multiple tunnel interfaces 

B. allows multiple authentication types to be used on the tunnel interface 

C. shares a single profile between a tunnel interface and a crypto map 

D. shares a single profile between IKEv1 and IKEv2 

Answer: A 


300-209 test engine

Improve 300-209 vce:

Q46. Which is used by GETVPN, FlexVPN and DMVPN? 

A. NHRP 

B. MPLS 

C. GRE 

D. ESP 

Answer: D 


Q47. Which two statements comparing.ECC and RSA are true? (Choose two.) 

A. ECC can have the same security as RSA but with a shorter key size. 

B. ECC lags in performance when compared with RSA. 

C. Key generation in ECC is slower and less CPU intensive. 

D. ECC cannot have the same security as RSA, even with an increased key size. 

E. Key generation in ECC is faster and less CPU intensive. 

Answer: A,E 


Q48. Refer to the exhibit. 


Which VPN solution does this configuration represent? 

A. DMVPN 

B. GETVPN 

C. FlexVPN 

D. site-to-site 

Answer: C 


Q49. Which option describes the purpose of the command show derived-config interface virtual-access 1? 

A. It verifies that the virtual access interface is cloned correctly with per-user attributes. 

B. It verifies that the virtual template created the tunnel interface. 

C. It verifies that the virtual access interface is of type Ethernet. 

D. It verifies that the virtual access interface is used to create the tunnel interface. 

Answer: A 


Q50. Scenario: 

You are the senior network security administrator for your organization. Recently and junior engineer configured a site-to-site IPsec VPN connection between your headquarters Cisco ASA and a remote branch office. 

You are now tasked with verifying the IKEvl IPsec installation to ensure it was properly configured according to designated parameters. Using the CLI on both the Cisco ASA and branch ISR, verify the IPsec configuration is properly configured between the two sites. 

NOTE: the show running-config command cannot be used for this exercise. 

Topology: 




Which transform set is being used on the branch ISR? 

A. Default 

B. ESP-3DES ESP-SHA-HMAC 

C. ESP-AES-256-MD5-TRANS mode transport 

D. TSET 

Answer: B 

Explanation: 

This can be seen from the “show crypto ipsec sa” command as shown below: